Used to measured curved and rough surfaces.
For more information on Filmetrics accessories, please contact our U.S. offices by calling +1 858-573-9300 (24 Hr, M-F) or contact us by e-mail.
Contact probe for measuring on flat or spherical samples. Ruggedized stainless steel monocoil.
Similar to the CP-1-1.3, except optimized to reject backside reflections (96% rejection for substrate 1.5mm thick.) PVC-coated steel monocoil. For thicknesses up to 15µm.
Contact probe for getting into tighter concave surfaces. 17.5mm diameter.
Contact probe for outside of cylindrical and spherical samples down to 6mm diameter.
Contact probe for outside of cylindrical and spherical samples down to 12mm diameter.
Contact probe for outside of cylindrical and spherical samples down to 26mm diameter.
Contact probe with 300mm of bendable length, 350mm of total probe length. Good for configuring for hard-to-reach areas, but is not self-aligning to surface.
Contact probe for reaching inside surfaces, such as the inside diameter of food and beverage cans
Our smallest diameter contact probe has a tiny right-angle mirror for measuring the inside of tubes down to 3mm ID. Is not self-aligning to surface.
This contact probe has a right-angle reflector to measure between flat surfaces placed as close as 10mm apart.
Contact Us Now
Learn about the importance of thin films with our animated short film, or see how easy it is to set up and use a Filmetrics system.More…